Device Setup

Follow the guided steps to connect your hardware, map the data we detect, and confirm the configuration.

Where is this device coming from?

Choose the origin that matches your hardware to tailor the onboarding process.

Confirm the device identifier

We use this identifier to listen for readings from your hardware.

Only hexadecimal characters are allowed. We will normalize the address before continuing.

Share this ingestion endpoint with your device to start streaming sensor readings:

We generate a unique identifier for each device to isolate data.

Configure your gateway to deliver batched readings to this endpoint:

Each payload should include the originating device identifier within the message body.

Map incoming sensor data

Power on the device and we will display readings in real time. Map each stream to a sensor type and location when it appears.

Listening for data sent by:

Confirm configuration

Review the mapped sensors below. You can go back to make changes before saving.